|
Jimi
Hendrix Octavio Pedal
DESCRIPTION
• A true rock and roll artifact —
Jimi’s original Octavio produced the unforgettable fuzzed-out octave
tones heard on the legendary Band of Gypsys:
Live at the Fillmore East Performance.
• An exact clone of the amazing,
“octave up” pedal that Jimi used to make rock
history.
POWER REQUIREMENTS
Single 9-volt alkaline battery
TECHNICAL SPECIFICATIONS
- Input
Impedance @ FUZZ CW............................ 15 K ohm
-
Input Impedance @ FUZZ CCW.......................... 187 K ohm
-
Maximum Input Level ......................................... -8 dB
-
Minimum Gain........................................................8
dB
-
Maximum Gain.......................................................37
dB
-
Output Impedance @ 1 KHz Max. Volume…....... 1.5 K ohm
-
Output Impedance @ 1 KHz -6dB Volume…....... 115 K ohm
-
Maximum Output Level ........................................ 1.7 V
P-P
-
Power Consumption.............................................4 mA @
9 VDC
-
Effect Switching .................................................True
Hardwire Bypass
*All Specifications are +/- 10%
DUN-JH-OC1
|
Jimi Hendrix Signature Wah Pedal
DESCRIPTION
• The original 60’s wah, with Jimi’s
custom modifications!
• Lowers the effect’s frequency range
for fatter, more open sound
• Vintage-style construction and
premium electronics
DIRECTIONS
To set up the Jimi Hendrix JH-1B Wah,
plug your instrument and amplifier cords
into the proper jacks. (The words
“Instrument” and “Amplifier” are on the rubber
footpad.) Press the pedal all the way
down to the toggle the Effect On footswitch.
Then you can control the wah effect
with the pedal travel. To turn it off, press
the pedal all the way down again. If
you rock the pedal all the way up and down,
you’ll get an intense wah effect. If
you rock the pedal within a limited range
(within an inch or less), you’ll get a
subtle effect.
POWER
Single 9-volt alkaline battery or
Dunlop ECB03 AC Adapter
CONTROLS
• Pedal sweeps 100K ohm Hot Potz
potentiometer for quick wah ramping
•
Effect On/Bypass toggle switch at bottom of pedal travel
TECHNICAL SPECIFICATIONS
- Filter Parameters
- Low Pass .................................290Hz -
310Hz
- High Pass .................................1400Hz
–1510Hz
- Input Impedance .......................800K
- Output Impedance.....................10K
- Maximum Input Level ................8.0dB
- Maximum Output Level .............+10dB
- Maximum Gain (Toe Down) ......+16.5dB .. @ 1400Hz ~
1510Hz
- Maximum Gain (Heel Down) .....+16.5dB .. @ 290Hz
~310Hz
- Power Requirements
..............................900µA
DUN-JH-1B
|
|
|
Jimi Hendrix Fuzz Face
DESCRIPTION
Hendrix
was the master of fuzz — an artist with many subtle
shadings
at his command. His love affair with the legendary
Fuzz
Face pedal began in the early days of the Experience and continued to
evolve throughout his brief but blazing career. The Dunlop Jimi
Hendrix Fuzz Face is a meticulously faithful reproduction of the
1969-70 Dallas Arbiter Fuzz Face that Jimi used on classic albums
like Band of Gypsys. Dunlop’s engineering department examined hoards
of vintage Fuzz Faces, honing in on a few units which possessed that
unmistakable
Jimi voodoo. The Hendrix Fuzz Face is built
around
the toneful BC108 silicon transistor. It is authentic in
every
detail, down to it’s hand-wired brown circuit board with
circuitry
carefully matched to the original specs. The look is
100%
accurate too—that groovy circular chassis with tooled
clones
of the original Fuzz Face knobs in the rare and vintage
turquoise
hammertone finish. A truly playable collectable for
any Hendrix or Fuzz Face fanatic.
POWER
Single 9 volt alkaline battery
CONTROLS
• Footswitch toggles effect on/bypass
• Volume knob controls total output
gain
• Fuzz knob controls intensity
(depth) of fuzz tone
TECHNICAL
SPECIFICATIONS
-
Input Impedance ............................10 Kohm
-
Output Impedance..........................@ 1 KHz Maximum Volume.2
Kohn
-
Output Impedance..........................@ 1 KHz-6dB Volume…115 Kohn
-
Maximum Output Level ..................-1.4 dBm (~540 mV P-P)
-
Maximum Gain (Toe Down) ...........500 uA @ 9 VDC
-
Effect Switching ............................THWBP
* All specifications are +/- 10%
DUN-JH-F1
|
|
